Yippeeee!

You've got new Pixii dispensers. Nice!

Let's get them up on your walls.

⚠️ Note the instructions below are for installing your dispensers via the pre-applied industrial-strength double-sided tape. If you wish to screw the dispensers to the wall, please use a masonry drill bit 6mm, and panhead screws.

⚠️ ⚠️ There are a few key points that, if ignored, may lead to your dispenser falling from the wall and cracking or breaking. Please follow all instructions carefully. Key points:

  1. Allow adhesive some time to cure BEFORE filling the dispenser
  2. If your space experiences big fluctuations in temperature or humidity (e.g. it is open-air or not air-conditioned), you may need to add some liquid nails or similar to help the double-sided tape, before sticking the dispenser up.

Important Notes

Before we begin...

⚠️ Note the instructions below are for installing your dispensers via the pre-applied industrial-strength double-sided tape. If you wish to screw the dispensers to the wall, please use a masonry drill bit 6mm, and panhead screws.

⚠️ ⚠️ There are a few key points that, if ignored, may lead to your dispenser falling from the wall and cracking or breaking. Please follow all instructions carefully. Key points:

  1. Allow adhesive some time to cure BEFORE filling the dispenser
  2. If your space experiences big fluctuations in temperature or humidity (e.g. it is open-air or not air-conditioned), you may need to add some liquid nails or similar to help the double-sided tape, before sticking the dispenser up. Check the liquid nails pack for suitability with acrylic and your substrate (tile, concrete etc) before use.

Find the position

Step 1

  • Allow space around other amenities
  • Check the dispenser is not behind a swinging door
  • The bottom of the dispenser should be between 1100 mm and 1300mm from the floor, for accessibility
  • Allow 35cm clearance above the dispensers (standard model only)
  • Allow a few cm clearance between the two dispensers if installing in a pair (standard model only)

Prep the surface

Step 2

  • Wall surface must be flat and smooth. If your wall is bumpy, uneven or rough, please use liquid nails or screws.
  • Do not put dispensers on a mirror. Mirrors require a special adhesive.
  1. Prep the smooth surface for double sided tape by cleaning with the supplied isopropyl alcohol wipes or any isopropyl alcohol cleaner.
  2. Wait. Allow a minute for the alcohol to evaporate.

Put it up 👌

Step 3

  • Empty the dispenser - if your dispenser was shipped with a packet of pads or tampons already inside, remove it. This will reduce the weight while the glue is still activating.
  • Peel and stick - peel off the backing tape. Stick the dispenser up.
  • Recommended - use a spirit level to make sure it's straight.
  • Hold - hold and press the dispenser firmly but gently against the wall for at least 30 seconds while the glue sets.
  • Fill and enjoy - you're done! BEST TO WAIT 24 HOURS if you can, then fill it up with a packet of period products. Then walk away smiling, knowing you're helping prevent period panic in another place.
  • Good job 👌💚

Everyone deserves to have their period needs met

Not all women menstruate, and not all who menstruate are women. Whoever you are, we support your right to accessible period products, and we're committed to creating an inclusive space for people of every gender identity.